Publicité
Les langues disponibles
Les langues disponibles
Please note:
If there is no valid operation within 20 seconds, the clock automatically returns to the normal time
mode.
Alarm setting
Push the "AL" switch to the "on" position, the LCD displays the "
issued BI-BI sound (Except for RC), the alarm function is ON. Push the "AL" switch to the "off"
position, the "
" icon will disappears from the display, the alarm function is OFF.
Press the "mode" button once and the LCD displays alarm time. Press and hold the "mode" button
for 2 seconds until hour of the alarm time starts to flash. Press the "+" and "-" buttons to set the hour.
Press the "mode" button to confirm your setting, The Minute of the Alarm time starts to flash. Press
the "+" and "-" buttons to set the minute.
Press the "mode" button to confirm your setting, the snooze time starts to flash. Press the "+" and
"-" buttons to set the snooze duration from 1-60 minutes.
Press the "mode" button to confirm your setting and to end the setting procedure.
Please note:
If there is no valid operation within 20 seconds, the clock automatically returns to the normal time
mode.
The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case
the alarm will be repeated automatically after 24 hours.
Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the alarm
signal is heard.
Switching off the alarm signal
When the alarm is ringing, press any button except the "Light/snooze" button to stop the alarm
signal. It is not necessary to reactivate the alarm. It will ring again this time next day.
Snooze function
When the alarm is ringing, touch the "Light/snooze" button the alarm mode will to get to SNOOZE
mode. The alarm signal sounds again after the set snooze duration.
RF Transmission Procedure
The weather station automatically starts receiving transmission from outdoor thermo sensor for
outdoor temperature & humidity after batteries inserted.
The remote sensor will automatically transmit temperature and humidity signal to the weather
station after batteries inserted.
If the weather station failed to receive transmission from outdoor sensor ("- -.-"display on the LCD),
press and hold the "CH" button for 3 seconds to receive transmission manually. RF icon flashes on
the LCD The weather station starts to receive the remote sensor.
If the weather station receives 2 or 3 transmitters signals, press the "CH" button to select CH2, CH3
data or cyclic display. The channel switch on the back of the transmitter must be set to a number
that fits the desired channel.
EN5
" icon. At the same time
Publicité
