Publicité
Les langues disponibles
Les langues disponibles
Initial operation:
Open the weather station battery compartment cover
Insert 2 x AA batteries observing polarity [ "+" and " –" marks]. These batteries are intended as
back-up for adapter.
Insert the provided power adapter and connect to the power socket.
Once the weather station is powered, all icons on the LCD will light up for 3 seconds, and you will
hear a beep tone, then indoor temperature & humidity will be displayed.
The Weather Station will now start to search for the outdoor remote sensor. This operation takes
about 3 minutes and will be indicated by a flashing reception RF antenna symbol in the
"OUTDOOR" display area on the receiver.
Open the remote sensor battery compartment cover and insert 2 x AA batteries observing polarity [
"+" and "–" marks]
After receiver has received the outdoor remote sensor, it will enter the radio controlled time
reception mode.
Reception of the Radio signal:
The clock will automatically search the DCF signal after 3 minutes of any restart or changing of new
fresh batteries. The radio mast icon starts to flash.
At 1:00 /2:00 / 3:00 AM, the clock automatically carries out the synchronization procedure with the
DCF signal to correct any deviations to the exact time. If this synchronization attempt is
unsuccessful (the radio mast icon disappears from the display), the clock will automatically attempt
another synchronization at the next full hour. This procedure is repeated automatically up to total 5
times.
To start manual DCF signal reception, press and hold the "Wave" button for two seconds. If no
signals received within 7 minutes, then the DCF signal search stops (the radio mast icon disappears)
and start again at the next full one hour.
During DCF reception, to stop searching radio signal, press the "Wave" button once.
Please note:
A flashing radio mast icon indicates that the DCF signal reception has started
A continuously displayed radio mast icon indicates that the DCF signal was received successfully
We recommend a minimum distance of 2.5 meters (8.2Feet) to all sources of interference, such as
televisions or computer monitors or switching power adapter.
When receiving the DCF radio wave, it will automatically turn off the USB charging and backlight.
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such
extreme circumstances, place the system close to the window.
During the RC receive mode, only the "Light/snooze" and "Wave" buttons have a function, other
buttons are not functional. If you want to use other functions, please press "Wave" button to exit
the DCF reception mode.
Manual time setting:
Press and hold the "mode" button for 2 seconds, the temperature unit starts to flash. Press the "+"
and "-" buttons to set the temperature unit to °C or °F.
Press the "mode" button to confirm your setting, 12/24HR start to flash. Press the "+" and "-"
buttons to set 12 or 24 hour mode.
Press the "mode" button to confirm your setting, the time zone starts to flash, Press the "+" and "-"
buttons set a time zone (-12 to +12).
Press the "mode" button to confirm your setting, the hour display starts to flash. Press the "+" and
"-" buttons to set the hour.
Press the "mode" button to confirm your setting, the minute display starts to flash. Press the "+"
and "-" buttons to set the minute.
Press the "mode" button to confirm your setting, the weather forecast starts to flash. Press the "+"
and "-" buttons to select the current weather.
Press the "mode" button to confirm your setting and to end the setting procedures, the clock
automatically returns to the normal time mode.
EN4
Publicité
