Campbell Hausfeld PW340200 Instructions D'utilisation page 11

Connect Spray Wand to Spray Gun
Thread the spray wand into the end of the spray gun.
Connect QC Nozzles to Spray Wand
Pull quick connect coupler back and insert nozzle. Release quick connect coupler and twist
nozzle to make sure it is secure in coupler.
\
Turn Water Faucet Completely On
Do not run the unit without water supply connected and turned on. Use Cold Water Only.
Release Air from System
Release all air from pump and high pressure hose by depressing trigger until a steady stream
of water is present. Approximately 30 seconds.
Verify the Fuel Switch is in the ON Position
Move the Choke to the CLOSED Position
Pull the Recoil Starter Grip
Pull the recoil starter grip to start the engine.
Move the Choke to the OPEN Position
Gradually move the Choke to the OPEN Position after engine starts.
This Guide is not a substitute for reading the operator's manual. User must read
and understand operator's manual before using this product.
9
Figure 8
Figure 9
Figure 10
30 S
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15