2. REASSEMBLING THE FRIDGE DOOR
AND THE SHOW CASE DOOR OF THE
FRIDGE
To reassemble the FRIDGE DOOR and the SHOW
CASE DOOR OF FRIDGE, assemble the parts in
reverse order.
3. REASSEMBLING THE WATER SUPPLY
LINES
1. Both water lines must be fully Inserted to the
center of the transparent coupler to prevent
water leakage from the dispenser.
2. Insert the clips in the install pack and check
that each clip holds each line fi rmly.
CAUTION
• Keep the clips out of the reach of children and
make sure that children do not play with them
or put them into their mouths.
• When reconnecting the supply hoses, make
sure you connect hoses of the same color
together.
DA68-03178A-03.indb 14
DA68-03178A-03.indb 14
Center of Transparent coupler
Center of Transparent coupler
Clip A (1/4")
Clip A (1/4")
(6.35 mm)
(6.35 mm)
English - 14
LEVELING THE REFRIGERATOR
AND ADJUSTING THE HEIGHT
AND GAP OF THE DOORS
How to level the refrigerator
If the front of the appliance is slightly higher than
the rear, the door can be opened and closed more
easily.
Setting up the refrigerator on an uneven surface
will cause the refrigerator to lean.
If the freezer side is lower:
• Insert a fl athead screwdriver into the height
leveler located at the bottom back of the freezer
door and turn it in the direction of the arrow
until it is level.
If the refrigerator side is lower:
• Insert a fl athead screwdriver into the height
leveler located at the bottom back of the
refrigerator door and turn in the direction of the
arrow until it is level.
2015. 1. 26.
2015. 1. 26.
11:58
11:58