Haier AC35S2SG1FA Mode D'emploi page 26

Installation Procedure
Cut intake grill for drain pipe
(1) Tools:Knife or Pliers.
(2) Cut the intake grill before installing the drain pipe,Then,pass the drain pipe through the hole.As the following schematic.
After removal
Location of the cut
Installing the drain pipe and the connecting pipe
(1) When the unit is installed in the ceiling,Installing them as below.
Ceiling
connecting pipe
drain pipe
(2) When the unit is installed on the floor,Installing them as below.
connecting pipe
Floor
drain pipe
CAUTION
When the unit is installed in the ceiling,side B is lower than side A for condensate discharge. As below.
10mm-15mm
10mm-15mm
B
A
A
B
24