Carrying Out A Factory Reset; Removing The Highway Head Unit - PURE Highway H250S Mode D'emploi

Installing the Highway head unit
1. Insert the mounting sleeve into the dashboard. Fix
it firmly in place by folding down the metal tabs.
2. Connect the audio, FM/MW antenna and
electrical cables to the back of Highway (see
page 16).
3. Install the detachable panel (see opposite) and
test Highway to check that all audio functions are
working properly.
4. Connect the digital antenna cable.
Note: See page 17 before connecting the
digital antenna cable.
5. Remove the two protective screws on the top of
Highway so that the CD function works and slide
Highway into the mounting sleeve and push to
secure in place.
6. Attach the outer trim frame.
If you are not sure how to install this unit
correctly, contact a qualified technician.
Mounting bolt
Rubber cushion
Mounting sleeve
Main unit
Trim plate
18
Installing the detachable panel
1. Line up the groove on the
right side of the face panel
with the slot on the unit.
2. Press down the left side of
the face plate until it clicks
into the panel slot.

Carrying out a factory reset

1. Remove the detachable panel as described on
page 5.
2. Press the RESET button with a pointed object
to reset Highway to factory settings.
3. Replace the detachable panel as described on
page 5.
Note: Pressing the RESET button will erase the
clock setting and stored stations.
Remove the
two screws
1
2

Removing the Highway head unit

1. Power off Highway.
2. Remove the detachable panel as described on
page 5.
2
3. Remove the outer trim frame.
1
4. Insert the L-key removal tools into the slots on
the front of Highway until they lock (as shown in
the diagram below).
5. Pull out Highway and disconnect all cables.