Mounting The Camera; Tools Required - Dometic GROUP WAECO PerfectView CAM50 Mode D'emploi

_CAM50.book Seite 30 Freitag, 20. Mai 2011 11:34 11

Mounting the camera

 Protect every through-hole made in the bodywork against water pene-
tration, e.g. by using a cable with a sealant and by spraying the cable and
the the cable sleeve with sealant.
I
NOTE
Do not start sealing the through-holes until all installation work has
been finished for the camera, and the required cable lengths have
been established.
8 Mounting the camera
8.1

Tools required

For installation and assembly you will require the following tools:
 Drill bit set (fig. 1 1, page 2)
 Drill (fig. 1 2, page 2)
 Screwdriver (fig. 1 3, page 2)
 Set of ring or open-ended spanners (fig. 1 4, page 2)
 Measuring ruler (fig. 1 5, page 2)
 Hammer (fig. 1 6, page 2)
 Centre punch (fig. 1 7, page 2)
To make and test the electrical connection, the following tools are required:
 Diode test lamp (fig. 1 8, page 2) or voltmeter (fig. 1 9, page 2)
 Insulating tape (fig. 1 11, page 2)
 Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
30
PerfectView CAM50
EN