Dometic GROUP WAECO PerfectView CAM50 Mode D'emploi page 32

_CAM50.book Seite 32 Freitag, 20. Mai 2011 11:34 11
Mounting the camera
I
NOTE
We recommend greasing the threads of the bolts to prevent
corrosion.
When mounting the camera, proceed as follows:
➤ Hold the camera on the chosen location and mark at least two different
points for the drill holes (fig. a, page 5).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws
(fig. b, page 5)
A
NOTICE! Risk of damage!
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 3 x 10 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig. c, page 5)
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 3.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M3 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
32
PerfectView CAM50
EN