Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
®
LUX-top
SDH-B
for attaching roofers' ladders and for attaching the personal protective equipment against falls
from a height
Introduction:
Before installing the anchor construction the load-bearing capacity of the roof structure must be checked.
The technical building regulations must be complied with.
Only original parts of the anchor point system may be used.
Note the installation and safety information in the user instructions.
1. Butt joint additional roof lath as
substrate for the roof hook on the
existing lathing and fix with nails (see
installation sketch).
Fix the
LUX - top
2.
in the following installation sketch
using the three woodscrews 8.0 x
mm supplied without predrilling; fix on
the lathing in the middle of the rafters
(min. 6/14 cm; min. strength class
C 24 to DIN EN 338).
IF THE REQUIRED MINIMUM ENGANGEMENT LENGTH IS NOT ENSURED DUE TO THE
ROOF CONSTRUCTION FOUND ON SITE, LONGER WOODSCREWS MUST REQUESTED
FROM THE MANUFACTURER!
ST QUADRAT Fall Protection S.A. – Ihr kompetenter Partner für Absturzsicherungen – www.lux-top-absturzsicherungen.de
roof safety hook
®
SDH-B
as shown
L
NOTE:
Ensure that the
®
LUX – top
SDH-B
positioned so that it fits
into
the
joins
of
roofing.
Screw length
L
is specified depending on the
existing roof structure.
Minimum engagement length
in the load-bearing structural member
(rafters) = 130 mm
Minimum rafter cross-section: 6 / 14 cm
Seite 2
is
the
04/15
Publicité
