Dyna-Glo DGA480BSP Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
5. Remove preassembled screws (GG) from
the door handles (J). Insert 2 door handle
sleeves (K) into the holes located on the
back of the left door assembly (H). Insert
2 screws (GG) into the door handle sleeves
(K) and into the threaded holes in the door
handle (J). Tighten the screws.
Repeat with right door assembly (I).
Hardware Used
GG
M5 x 10 Screw
6. Attach the left door assembly (H) to the cart
body by aligning the holes in the hinge of the
left door assembly (H) with the holes in the
cart left side panel (D), inserting 4 screws
(DD) and tightening.
Repeat with right door assembly (I).
Hardware Used
DD
M4 x 10 Screw
5
x 4
6
DD
x 8
9
GG
J
K
D
H
H
E
I