Dyna-Glo DGA480BSP Mode D'emploi page 12

ASSEMBLY INSTRUCTIONS
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 11.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
11. Open the lid and place the four heat tents (X)
on the brackets directly above the burners.
12. Place cooking grates (Y) on the grill body
braces and grill rear panel, then insert the
warming rack (W) into the 2 holes located
on the back edge of the grill body (O).
11
VALVE
ORIFICE
12
12
O
Y
X
W