Dyna-Glo DGA480BSP Mode D'emploi page 18

CARE AND MAINTENANCE
BURNER ASSEMBLY
REMOVING THE BURNER ASSEMBLY
1. Make sure all control knobs are in the OFF
position, LP tank valve is closed, and tank
is disconnected from regulator and removed
from grill.
2. Open lid and remove warming rack, cooking
grates, and heat tents.
3. Remove cotter pins at back of burners to detach burners from brackets.
Cotter Pin
Burner
4. Slide burners out of firebox as shown.
5. Detach ignition wire from ignitor as shown.
18
Warming Rack
Cooking Grates
Heat Tents
Burner
Bracket