Troubleshooting - Beem Ecco De Luxe Mode D'emploi

Ecco De Luxe 4 in 1
The following table helps in localising and remedying minor faults:
Fault
The display lighting does
not light up after inserting
the mains plug.
The automatic circuit
breaker in the electrical
distribution board trips.
Kettle (10) cannot be
switched on. Power indica-
tor does not light up.
Kettle (10) does not auto-
matically switch off.
Kettle (10) switches off
prematurely.
Filter compartment (22)
cannot be swivelled out
properly.
Coffee flows into the ther-
mos jug (19) too slowly.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
customer service.
34

Troubleshooting

Possible cause
Automatic circuit breaker in
electrical distribution board
tripped.
Display lighting defective
Too many appliances connect-
ed to the same power circuit.
No fault detected.
Kettle (10) is not standing on
the socket properly (13).
On/off switch (9) is blocked.
Lid is not closed properly.
Boil-dry safety protection was
triggered
Permanent filter (24) and/or fil-
ter holder (23) are not properly
positioned in the filter compart-
ment (22).
Drip-stop (21) is blocked.
Coffee machine scaled.
Remedy
Switch on the automatic
circuit breaker again.
Contact customer service.
Reduce the number of
appliances on the power
circuit.
Contact customer service.
Put the kettle (10) onto
the socket (13) so that it
snaps in properly.
Remove the blockage.
Close lid.
Reset the dry-boil protec-
tion as described in the
section Resetting the
boil-dry protection
(page 28).
Pay attention to the
proper positioning of the
permanent filter (24) and
the filter compartment
(23).
Clean the drip-stop (21).
Descale coffee machine.
See section Descaling
(page 31).
BEEM - Elements of Lifestyle
EN