DSC Neo Power Séries Instructions D'installation page 6

[022] Second Keypad Options
Default Value Option
ON I__I 1 Local Clock Display ON
OFF I__I 2 Local Clock Displays 24-hr
ON I__I 3 Auto Alarm Mem Scroll ON
ON I__I 4 For Future Use
OFF I__I 5 Power LED Enabled
Power LED Indicates AC Present
ON I__I 6
ON
ON I__I 7 Alarms Displayed While Armed
OFF I__I 8 Auto-Scroll Open Zones ON
Note:For UL/ULC installations, bit 5 (Power LED) and bit 6 (Power LED IndicatesAC Present)
shallbe ON.
[023] Third Keypad Options
Default Value Option
OFF I__I 1 Armed LED Power Save
ON I__I 2 Keypad Status Shows Stay Arm
5th Terminal is Keypad PGM Out-
OFF I__I 3
put
ON I__I 4 Prox tag will arm/disarm
OFF I__I 7 Local Display of Temperature
OFF I__I 8 Low Temperature Warning Enabled Low Temperature Warning Disabled
[030] Download LCD Messages
I___I___I___I___I___I___I___I___I___I___I___I___I___I ___I
I___I___I___I___I___I___I___I___I___I___I___I___I___I ___I
[031] Download LCD Message Duration
Default: 000 I___I___I___I
(Valid entriesare 000-255, 000=Unlimited Msg Display) Thisnumber representsthe number
of timesthe downloaded message must be cleared before it ispermanentlyremoved. This
message can be cleared bypressing anykey.
[041] Indoor Temperature Zone Assignment
Default: 000 I___I___I___I (Valid entries are 000-128)
[042] Outdoor Temperature Zone Assignment
Default: 000 I___I___I___I
[101] - [228] Door Chime for Zones 1 - 128
ON Off
Local Clock Display OFF
Clock Displays AM/PM
Auto Alarm Mem Scroll OFF
For Future Use
Power LED Disabled
Power LED Indicates AC Present
OFF
Alarms Not Displayed While Armed
Auto-Scroll Open Zones OFF
ON Off
Armed LED Off in Sleep Mode
Keypad Status Shows Stay/Away
Arm
5th Terminal is Keypad Zone Input
Prox tag does not arm/disarm
No Local Display of Temperature
(Valid entries are 000-128)
The keypad can be programmed to make up to four different chime soundsfor individual
zones(e.g., for Zone 1, enter section [101], for Zone 2 enter section [102]).
Default: 01 I___I___I
Valid Entries
01 6 Beeps
02 Bing-Bing tone
03 Ding-Dong tone
04 Alarm tone (4 second duration)
05 Zone name
[991] Reset Keypad Programming to Factory Defaults
1.
Press [*][8][Installer Code].
2.
Enter [991].
3.
Use the [<][>] keys to scroll to the applicable keypad.
4.
Press [*] to select the keypad.
5.
Re-enter [Installer Code].
6.
Press [*] to reset the selected keypad to factory defaults.