Technical Data; Notes.on.safety; Symbols Used In The Instructions - FLORABEST FLB 2500 A2 Traduction Du Mode D'emploi D'origine

guide rollers at the lower end of the tube
make it easier to guide the tube along the
ground.To.protect.the.user,.the.ap-
pliance.can.only.be.used.with.the.
blowing/suction.pipe.completely.
installed..The.appliance.is.double-
insulated,.and.does.not.need.to.be.
earthed.
Refer to the following descriptions for instruc-
tions on how the operating controls work.

Technical Data

Leaf.blower................
Rated input voltage .................220-240V,
Input power .............................. 2500 W
Safety class ...................................
Protection category......................... IP 20
Air capacity .................. max. 15 m
Air speed ....................... max. 270 km/h
Shredding rate ........................ max. 10:1
Content of the collection bag ............. 50 l
Weight (incl. accessories kit).......... 5,5 kg
Sound pressure level
(L ) ........... 86,0 dB(A); K
pA
Sound power level (L
measured ...101,0 dB(A); K
guaranteed ......................... 103,0 dB(A)
Vibration (a )
n
at the handle .............................9,7 m/s
at the additional grip .............9,3 m/s
Noise and vibration values were deter-
mined according to the standards and
stipulations designated in the Declaration of
Conformity.
Noise and Vibration: The operating condi-
tions during measuring and the procedures
used for measuring in accordance with
EN 15503, Appendix A, Appendix B.
FLB.2500.A2
50/60 Hz
/min
3
= 3,0 dB(A)
pA
)
WA
= 2,0 dB(A)
wA
K=1,5 m/s
Technical and optical changes can be car-
ried out in the course of the further develop-
ment without announcement. All measures,
references and information contained in
this operating manual are therefore without
guarantee. Legal claims, which are made
on the basis of the operating manual, can-
not be considered.
This device is designed for operation on
a power supply network with a system
impedance Zmax at the transfer point
(domestic connection) of a maximum of
0.28 Ohms.
The user must ensure that the device is
operated only on a power supply network
that fulfils this requirement. If necessary,
the local power supply company can be
/ II
asked for the system impedance.
Notes on safety
This section deals with the basic
safety regulations to be observed
when working with the machine.
Symbols used in the instruc-
tions
. Hazard.symbol.(explanation.
of.hazard.partly.instead.of.
2
exclamation.mark).with.in-
2;
formation.on.prevention.of.
2
personal.injury.and.property.
damage..
Precaution symbol (explanation of
precaution partly instead of excla-
mation mark) with information on
prevention of harm / damage.
Notice symbol with information on
how to handle the device properly.
GB
53