Water refrigerated
reduces or even no
refrigeration
Running with shock
& loud noise
PARTS LIST
1.Front draft hood 2.Filter(Front draft hood ) 3.Control & command panel
4.Front cover 5.Circuit board 6.Back cover of circuit board 7.Seal sleeve
8.Middle top cover 9.Pipe connector 10.Nut 11.Condenser 12.Back cover
13.Handle 14.Filter (Side draft hood ) 15.Side draft hood 16.Middle nether
cover 17.Fan motor 18.Compressor 19.Base 20.Tank (with evaporator )
The compressor runs
normally, the fan stops
running, the unit can't
dissipate heat
The set temperature is
higher than the quarium
water temperature
The air inlet and outlet
are clogged with dirt
Refrigerant is not
enough
Too much water in
aquarium
The base is not flat
13
unit will turn on again
automatically
Replace with a new fan
of the same specs
Reset refrigerate
temperature
Remove the dust at the
air inlet/outlet with a
brush or a vacuum
cleaner
Look at page 2, fill the
unit with the same type
of refrigerant by a
qualified electrician
Reduce the water
Mount it on a flat base