Aquadistri SF HC100A Mode D'emploi page 22

will affect the refrigeration. If the chiller is placed under a fish tank fitted with a
filter, a water intake tube must be provided with the water pump which arrives
directly to the input connector on chiller to ensure the intake water is pure.
Please note that the filter (with the pump) must be located below the aquarium
water level. If you wish to place the unit at the side of the aquarium, you must
do so only after priming it.
BEFORE STARTING THE OPERATION OF THE CHILLER, PLEASE
CHECK THE FOLLOWING POINTS:
(1) Check if the water level inside the aquarium is appropriate.
(2) Make sure that no water leakage from the hose connections.
(3) Insert the power plug with its full contact into the power outlet so that the
plug itself does not wobble.
(4) Make sure there is nothing wrong with the water circulation & filtration
system, especially the circulating tube must not be clogged.
OPERATION
Note: Before starting the chiller, you must run the pump & make sure that there
is water in the aquarium and nothing wrong with the water circulating system.
There are three buttons for switching or setting temperature on the control &
command panel.
AQUARIUM WATER TEMPERATURE APPEARS & SET TEMPERATURE
APPEARS
Press the "SET" button for a short period of time, the aquarium water
temperature and the set temperature will appear alternatively on the display.
The indicator "2" turns off to indicate the aquarium water temperature. When
the indicator twinkles, it indicates the set temperature.
ADJUST THE SET TEMPERATURE
Press the (SET) button for more than three seconds to indicate that the
programming function is enabled and the previously set temperature value will
9