Installation Methods - Aquadistri SF HC100A Mode D'emploi

other damage. (Fig.6)
(7) Do not put the unit up side down; it will cause damage to the unit. If it is
put side down due to draining water or other reason for a short period of time,
put it straight and wait for 20 minutes before switching it on. (Fig.7)
SUGGESTIONS FOR INSTALLATION :
1. Electrical work must be done by a qualified electrician.
2. Provide a separate power outlet to be used only for the unit.
3. Ensure that the power source to be utilized conforms to the power
requirements specified on the product nameplate.
4. The power supply should be fitted with earth leakage breaker.
5. Disconnect the power during installation.

INSTALLATION METHODS

Note: The chiller must be operated with circulation & filtration system.
The chiller can be installed in a hidden position such as inside an closed style
aquarium cabinet. But if your cabinet has no ventilation grilles, they must be
made. When the grilles are being made, make sure the air intake grilles must
be in exact alignment with the aspiration grilles of the chiller and the air outlet
grilles on the cabinet should be made as high as possible for easy air outlet.
The chiller should be installed with its back as near as possible to the grilles of
the cabinet to allow for fresh air circulation. The chiller also can be installed
under an open style aquarium cabinet. As you know, it should be installed at a
minimum distance of at least 20-40 cm from each side of the cabinet, so as to
allow a fresh air flow in the intake area. For fresh air circulation, it is suggested
to put your chiller out of the aquarium cabinet. For sea water, it must be
filtered before arriving at the chiller, or the evaporator will become dirty and this
8