Aquadistri SF HC100A Mode D'emploi page 25

STEPS OF FILTER CLEANING
1. Loosen screw of front draft hood, turn counterclockwise ( Fig.1 ).
2. Draw front draft hood out lightly by hands ( Fig.2 ).
3. Loosen screws of the air filter ( Fig.3 ).
4. Remove the filter ( Fig.4 ).
5. Remove the dust completely with a brush or a vacuum cleaner ( Fig.5 ).
6. Install all the parts back by counter steps.
A GUIDE TO SIMPLE PROBLEM SOLVING
Before calling service personnel, please check the following chart for possible
cause to the trouble you are experiencing.
SYMPTOM
No power source. The
unit doesn't run & the
display appears nothing
The unit repeats
on and off
CAUSE
Power is not turned on
Plugged in insufficiently
The fuse has broken
Apply to wrong voltage
and frequency
The unit protection
device to be responding
12
COUNTERMEASURE
Turn on the power
Be sure the power cord
is fully plugged in
Change a new one
Apply to correct power
source according to the
nameplate.
A. Check if the water
circulation is normal
B. If the fan and the chiller
dissipate heat normally,
wait for 3 minutes & the