Intended Use; Technical Data; Machine Features; Assembly - Festool VN-HK 85 130x16-25 Mode D'emploi

GB VN-HK85 130X16-25
Routing wood
Uncertainty
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3

Intended use

The HK 85 portable circular saw can be turned into
a groove cutter in combination with this groove unit.
The groove cutter is designed for guided routing in
wood and materials similar to wood with dust ex-
traction. It is not suitable for making angled cuts or
plunge cuts.
Only use the original Festool adjustable grooving
cutter .
The machine is designed and approved for use by
trained persons or specialists only.
The user is liable for improper or non-in-
tended use.
4

Technical data

Groove unit
Max. routing depth
with guide rail/cross
cutting guide rail
Milling width
Cutter diameter
Weight
5

Machine features

[1-1] upper guard with support plate
Extractor connector
[1-2]
[1-3] Adjustable grooving cutter
lower guard
[1-4]
10
a < 2,5 m/s
h
K = 1,5 m/s
VN-HK85 130x16-25
35 mm
31 mm
16 - 25 mm
130 mm
0,9 kg
6

Assembly

2
2
Risk of injury, electric shock
Always pull the mains plug out of the socket be-

fore performing any type of work on the ma-
chine!
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-

tive.
Wear protective gloves.

Removing the saw blade
Swivel saw to 0° position before replacing the

saw blade and set maximum cutting depth.
To replace the saw blade, place the saw on the

edge of the table.
Turn lever [2-2] as far as stop.

Open the screw [2-5] using the Allen key[2-1].

Hold the pendulum guard open [2-8] only with

retractor lever [2-3].
Remove the saw blade [2-4] with clamping

flange [2-6] and rear flange[2-7].
Carefully release the retractor lever [2-3] and

allow the pendulum guard to swivel back [2-8]
to its final position.
Fitting the groove unit

Follow the fitting sequence.
1. Lower guard
Push the lower guard [3-1] onto the pendulum

guard of the portable circular saw.
Push it until the locknut is seated behind the

pendulum guard of the portable circular saw
[3A] – push it as far as possible. The screws will
need to be loosened slightly in order to do this.
Tighten the two screws [3-2] using a Torx span-

ner (left-hand thread).
2. Upper guard
Push the upper guard [4-1] onto the cover of the

portable circular saw.
WARNING
CAUTION