Accessories - Festool KP 65/2 Mode D'emploi


Push the edge trimmer from the
front towards the workpiece up to the
stop pin [1-4] until the glued edge
band makes contact with the inner
stop [1-7] [7].

Move the edge trimmer so that the
mark is positioned approximately in
the trimming fixture with blade [1-5].

The fine adjuster for the edge length
[1-3] can be used to adjust the edge
band with the marking more accu-
rately [8].
The edge length scale [1-1] indicates
whether more or less of the edge
band must be trimmed:
• Clockwise rotation: shorter edge
band, more of the edge band is
trimmed -
• Anticlockwise rotation: longer edge
band, less of the edge band is
trimmed +

If the marking is located directly be-
hind the blade on the trimming fix-
ture [1-5], push the handles [1-6] to-
gether and trim the edge band [9].
Caution, sharp blade! Risk of
injury! Keep fingers well away
from the blade on the trim-
ming fixture [1-5].

After trimming the workpiece, affix
the edge band with adhesive to the
workpiece using a hot air blower, for
example.
8

Accessories

Always use accessories and consumable
materials approved by Festool. See Fes-
tool catalogue or www.festool.com.
8.1 Trimming fixture with blade
The trimming fixture with blade [1-5]
produces a clean, accurate cut.
– Always use
blades.
– Replace blunt or damaged blades.
Changing blades [10]

Slacken the screws using a cross-
head screwdriver [10-1].

Remove the blade [10-2].

Keep the shims in position [10-3].

Place the blade [10-2] over the
shims [10-3].

Tighten the screws using a cross-
head screwdriver [10-1].
KP 65/ 2
sharp, undamaged
GB
11