Installation; Safety; General Safety Instructions; Instructions, Standards And Regulations - Stiebel Eltron SBS 800 W Manuel D'utilisation Et Installation

installation

safety

4. Safety
4.1

general safety instructions

The installation and commissioning must only be carried out by a
contractor. During this process the installation instructions must
be observed.
We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
4.2

Instructions, standards and regulations

4.2.1

Water installation

DIN 1988: Technical rules for potable water installations
DIN 4109
Regulations of the relevant water utility company.
Cold water pipe material: Steel, copper or plastic pipe systems.
Hot water pipe material; Copper or plastic pipework systems.
Any plastic pipework system must be designed to withstand the
maximum possible conditions (temperature and pressure) in the
event of a fault.
4.2.2 Energy Saving Act (ENEG)
— The hot water pipe must have thermal insulation.
— The DHW temperature in the pipework is restricted to a maximum
of 60 °C through automatic devices or other measures. This does
not apply to DHW systems that require higher temperatures or
need cable lengths of less than 5 m.
— DHW systems shall be equipped with automatic devices to shut
down the circulation pump.
5.

Equipment description

5.1

SBS 800 | 1000 | 1500 w | w Sol

The connector allocations for
— heat pump flow and return
— additional heat source flow and return
— heating flow and return
are matched to the standard system scheme.
Alternative allocations for different system components are
possible.
Modified connector allocations and non-observance of the intended
maximum flow rate can impair the delivery capacity.
14 | sBs w | sBs w sol
5.1.1 Hydraulic connector allocation
Connector allocation SBS 800 | 1000 | 1500 W | W SOL
17
15
11
16
12
14
1 Hot water
2 Cold water
3 Additional heat source flow
4 Additional heat source return
5 Heat pump flow, DHW
6 Heat pump return, DHW
7 Heating flow
8 Heating return
9 Heat pump flow, heating
10 Heat pump return, heating
11 Internal indirect coil solar, flow (only SBS...W SOL)
12 Internal indirect coil solar, return (only SBS...W SOL)
13 Connector for threaded immersion heater BGC
14 Drain connector
15 Air vent valve connector
16 Type plate
17 Lifting eyes
1
3
5
13
4
6
7
9
2
8
10
www.stiebel-eltron.com