Comelit MiniTouch Mode D'emploi page 11

SETUP
The settings required in order to use the Minitouch device with Vedo
series control units are illustrated below.
1. SET THE RS485 BUS ADDRESS
Access the menu Setup > Advanced > RS485 bus address.
1
9
This menu requires entry of the same RS485 bus address as set on the
Vedo series control unit in use.
2. SET THE RS485 BUS SPEED
Access the menu Setup > Advanced > RS485 bus speed.
This menu requires entry of the same RS485 bus speed as set on the
Vedo series control unit in use.
Thu 08/09/13 - 16:07 0W
1
2 3 4
0
Thu 08/09/13 - 16:07 0W
9600
38400
56700 56700
115200 115200
5
6 7
C
8
EN