Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
Troubleshooting
Drying process takes too much time.
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
Filter drawer is clogged.
•
Ventilation grids on the front side of the machine are blocked.
objects (if any) that block ventilation in front of the ventilation grids.
•
Ventilation is not sufficient since the room where the machine is installed is
very small. >>> Open the door and window of the room to avoid the room
temperature increase too much.
•
Lime deposit has built up on the dampness sensor. >>> Clean the dampness
sensor.
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
•
It is likely that the selected programme did not suit the laundry type.>>>Checking
the care labels on clothes, select appropriate programme for the laundry type or
use timer programmes in addition.
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter
drawer.
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start
when it is set.
•
It is not plugged in. >>> Make sure that the machine is plugged in.
•
The loading door is ajar. >>> Make sure that the loading door is closed securely.
•
Programme is not selected or the Start / Pause / Cancel button is not pressed.
>>> Make sure that the programme is selected and the machine is not in Pause
mode.
•
Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
•
Loading door is ajar. >>> Make sure that the loading door is closed securely.
•
There was a power failure. >>> Press Start / Pause / Cancel button to start the
programme.
•
Water tank is full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
•
A programme suitable for the laundry type is not used. >>> Check the garment
tag and select a programme suitable for the fabric type.
>>> Clean the sponge and the filter cloth in the filter drawer.
26 EN
>>> Remove the
Publicité
Table des Matières
