Before Starting Up; Starting Up - Comedes Lavaero 1000 Manuel D'utilisation

Before starting up

Remove the filter elements from the unit, remove the protective films and reinsert them into
the unit. Follow the steps in the chapter "Filter change". The filters should normally be changed
every 6-9 months.

Starting up

Inserting the device
When you plug in the device, the power LED lights up.
Caution: Never insert or remove the device with wet hands.
POWER
The power switch is used to turn the unit on and off.
(The symbol lights up red in standby mode and orange when switched on).
The device always starts in automatic mode.
AUTO
Press the "AUTO" button to start the automatic mode. In this mode, the fan level is
automatically selected depending on the air quality. If the mode is active, the
"AUTO" button lights up. The ionizer and the UV light are switched on in this mode.
However, by pressing the "IONIZER" or "STERILIZE" button on the remote control,
the ionizer or UV light can be turned off. To switch from automatic mode to manual
mode, press one of the two "SPEED" buttons.
Relationship between PM2.5 measured value, fan stage and color indicator
fan stage
1
2
3
4
Timer
With the timer you can set the running time of the device. Times between 1 and 12
hours can be selected. If the display shows 12 and you press the button again, the
timer is switched off.
When the time has elapsed, the unit switches off automatically.
If the timer is active, the corresponding button lights up and the display shows the
remaining runtime is displayed.
Ionizer (IONIZER)
This button on the remote control switches the ionizer on and off.
The unit always starts with the ionizer switched on.
If the ionizer is switched on, the corresponding indicator on the display lights up.
EN-8
PM2.5
colour
Measured
indicator
value
0-50
green
51-80
81-100
Blue
101-120
PM2.5
fan stage Measured
value
5 121-140
6 141-160
7 161-300
8 301-500
www.comedes.com
colour
indicator
Yellow
red