Comedes Lavaero 1000 Manuel D'utilisation page 28

UV light (STERILIZE)
This button on the remote control switches the UV light on and off.
The unit always starts with the UV light switched on.
If the ionizer is switched on, the corresponding indicator on the display lights up.
Sleep
In this mode, the device operates at the lowest fan speed for minimal noise.
Except for the Sleep display, all displays go out.
If a running time has been set via the timer before the start of the sleep function,
this setting remains and the device switches itself off after the time has elapsed.
To exit Sleep mode, press either Sleep, Auto or one of the two Speed buttons
twice in succession.
Light sensor
The air purifier is equipped with a modern light sensor. If the unit works in
automatic mode, both the air quality and the light intensity are monitored. If it is
dark in the room for longer than 2 minutes, the device automatically switches to
sleep mode. If the room is illuminated for longer than 3 minutes, the unit returns
to normal automatic mode.
Speed
Press the "+" key to increase the fan speed.
Press the "-" key to lower the fan speed.
The set fan level (1-8) is shown on the display.
Child lock (Lock)
Press the "CHILD LOCK" button to activate the child lock/key lock. If the
parental control is activated, the corresponding key lights up.
Press and hold this button again for at least 5 seconds to release the key lock.
The child lock is activated by pressing the "LOCK" button on the remote control
and deactivated by simply pressing the "UNLOCK" button.
Filter change indicator and filter reset
The Comedes Lavaero 1000 has a modern filter change indicator.
After 320 hours, the filter change symbol starts flashing. This is to inform you
that the prefilter and the HEPA element should be cleaned. After cleaning and
reinserting the filters, press and hold the "Reset" button for at least 5 seconds to
reset the filter timer.
After 1500 hours, the filter change symbol lights up continuously. This will
indicate to you that the two main filters should be replaced. After changing the
filters, press and hold the "Reset" button for at least 5 seconds to reset the filter
timer.
Depending on the type and intensity of use, the filter may have to be replaced
before the filter change indicator lights up. Therefore, check the filter regularly.
EN-9 www.comedes.com