Before Commissioning; Commissioning - Comedes Lavaero 280 Mode D'emploi

Before commissioning

Remove the filter elements from the device, remove the foils and reinsert them into the
device. Follow the steps in the chapter "Filter change". The main filter should normally
be changed every 6-9 months.
The order of the filters is marked with the numbers 1-3 on the filter flaps, with the filter
1 located completely outside.

Commissioning

1. Inserting the device
When you plug in the device, the readiness for operation is signalled
acoustically. Caution: Never insert or remove the device with wet hands.
POWER
2.
The power switch is used to turn the unit on and off.
AUTO
3.
If you use the unit in automatic mode, the fan is controlled via the air quality sensor. In
addition, the current air quality is shown quantitatively and qualitatively on the display.
air quality
remedy
Timer
4.
With the timer you can set the running time of the device. Times between 1 and
•
10 hours can be selected.
When the time has elapsed, the unit switches off automatically.
•
If the timer is active, the display will alternately show the PM2.5 concentration and
•
the remaining running time.
If no running time is set via the timer, the device switches itself off automatically after
•
a running time of 24 hours.
This prevents the air purifier from continuing to operate unattended for a long period
if it is not switched off.
ENG-7
PM2.5
(µg/m3)
good 20-70
71-150
Bad 151-
200
Very 201-
Bad 300
Display
Air-quality good
Lights green
Air-quality medium
Glows orange
Air-quality poor
Glows red
Air-quality poor
Flashing red
www.comedes.com
fan stage
1
2
3
4