Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
•
9/16" Socket Wrench (2)
Hitch Bracket Assembly
Assembling Hitch Bracket Assembly
1.
Insert the ends of the rear support bracket
through the narrow slots at the rear of each
side support bracket. See Figure 1-1.
2.
Secure folded tabs on rear support bracket to
side support brackets with a carriage screw
(ref. #9) and nylon lock nut (ref. #11). See Figure
1-1.
NOTE: The latches on the side support
brackets must be positioned with the opening
facing down on the outside of the bracket and
the tabs on the rear support bracket must be
facing up. See inset in Figure 1-1.
Figure 1-1
3.
Flip over bracket assembly and mount the
bracket support assembly (ref. #2) on the
center hole of the rear support bracket using
the hex screw (ref. part #10) and flange lock
nut (ref. part #12). See Figure 1-2.
NOTE: It may be easier to leave the hex
screw and flange lock nut only finger tight
until mounted on the mower to ensure
components properly align when installing on
mower.
4.
Attach the rubber grommet to the pin at the
bottom of the bracket support assembly. See
inset in Figure 1-2.
Figure 1-2
Required Tools
•
1/2" Socket Wrench (1)
Installing Hitch Bracket Assembly
If your mower is equipped with a K-62
transmission you will need to remove the
Hitch Support Bracket (ref part #4) from the
Fast Attach Support Bracket Assembly before
mounting the hitch to the tractor. To remove
the bracket, use a T-30 torx drive to remove
the two torx screws securing the assembly. See
Figure 1-3.
Figure 1-3
1.
Flip complete hitch bracket assembly over
when ready to install.
2.
Pull back j-pins and lock open by twisting
them inward slightly and letting them rest
on the back of the rear support bracket. See
Figure 1-4.
Figure 1-4
3.
Slip the pin at the bottom of the bracket
support assembly into the hitch adapter on
the rear of the mower frame at a slight angle.
See 1 in Figure 1-5.
4.
Ease the hitch bracket assembly forward over
the shoulder bolts on the sides of the mower
frame. See 2 in Figure 1-5.
•
7/16" Socket Wrench (2)
5.
6.
Cargo Carrier Assembly
IMPORTANT! Before attempting to install the Cargo
Carrier, make sure that all components are present.
Fully assemble the Hitch Bracket Assembly and
attach it to the mower.
7.
•
T-30 Torx (If needed)
Release the j-pins from the rear of the bracket
assembly. See 3 in Figure 1-5.
IMPORTANT! Make sure latches are fully
engaged with the shoulder bolts on the side
of the mower frame before attempting to
operate, or add any other attachment.
Figure 1-5
Fully tighten the hardware from step 3 if
previously left finger tight.
Fasten a shoulder screw (ref. #22) and flange
lock nut (ref. #20) from the hardware pack
onto the two cargo hinge brackets as shown in
Figure 1-6.
Figure 1-6
NOTE: Be sure the hardware is installed with
the shoulder screw coming from the outside
inward on both the right and left side brackets.
3
Publicité
Table des Matières
