JVC KD-ADV6580 Manuel D'instructions page 51

Menu operations
• <AUTO> setting for <DIMMER> may not work
correctly on some vehicles, particularly on those
having a control dial for dimming.
In this case, change the <DIMMER> setting to any
other than <AUTO>.
• If you change the <AMP GAIN> setting from
<HIGH POWER> to <LOW POWER> while the
volume level is set higher than "VOLUME 30," the
unit automatically changes the volume level to
"VOLUME 30."
Title assignment
• If you try to assign titles to more than 30 station
frequencies, "NAME FULL" appears. Delete unwanted
titles before assignment.
Output signals through the DIGITAL OUT terminal
Output signals are different depending on the "DIGITAL AUDIO OUTPUT" setting on the setup menu (see page
46).
Playback Disc
DVD-Video 48 kHz, 16/20/24 bits
Linear PCM
96 kHz, Linear PCM
Dolby Digital
MPEG Audio
Audio CD, Video CD
MPEG
MP3/WMA
WAV
* Digital signals may be emitted at 20 or 24 bits (at their original bit rate) through the DIGITAL OUT terminal if the
discs are not copy-protected.
Disc setup menu
• When the language you have selected is not recorded
on a disc, the original language is automatically used
as the initial language. In addition, for some discs,
the initial languages settings will not work as you set
due to their internal disc programming.
• When you select "16:9" for a picture whose aspect
ratio is 4:3, the picture slightly changes due to the
process for converting the picture width.
• Even if "4:3 PAN SCAN" is selected, the screen size
may become "4:3 LETTERBOX" for some discs.
DOLBY DIGITAL/
STREAM/PCM
48 kHz, 16 bits stereo Linear PCM *
48 kHz, 16 bits stereo Linear PCM
Dolby Digital bitstream
MPEG bitstream 48 kHz, 16 bits stereo Linear PCM
44.1 kHz, 16 bits stereo Linear PCM /
48 kHz, 16 bits stereo Linear PCM
44.1/48 kHz, 16 bits Linear PCM
32/44.1/48 kHz, 16 bits Linear PCM
44.1 kHz, 16 bits stereo Linear PCM
Output Signal
PCM ONLY
PCM
48 kHz, 16 bits
stereo Linear PCM
Continued on the next page
REFERENCES
OFF
OFF
51