Troubleshooting - Storch VacTec 30 M Mode D'emploi

Clean / replace the cooling air filter
M
2.
1.
1.
Allow device to cool down.

Troubleshooting

DANGER
First pull out the plug from the mains
before carrying out any tasks on the
machine.
Suction turbine does not
run
Suction turbine turns off
Suction turbine does not
start again after the con-
tainer has been emptied
Release the cooling air flaps with
screwdriver and swivel them out.
Clean (vacuum, wash) or replace the
cooling air filter.
3.
Fold in the cooling air flaps and snap
them in place.
Cleaning the electrodes
2.
Release and remove the suction head.
Clean the electrodes with a brush.
Insert and lock the suction head.
In case of a failure (e.g. filter brea-
kage) the appliance must be turned
off immediately. The failure must be
remedied before the appliance is put
into operation again.
- Check the receptacle and the fuse of the power
supply.
- Check the power cable, the power plug, the
electrodes and the receptacle of the device.
- Turn on the appliance.
- Empty the container.
- Insert flat folded filter.
- Turn off the appliance and wait for 5 seconds,
turn it on again after 5 seconds.
- Clean the electrodes as well as the space bet
ween the electrodes with a brush.
121
NOTE
Translation of the original instruction