Getting Started - Steba LB 8 Mode D'emploi

Getting started

∙ Use the device from a room temperature of 20 ° C and a humidity less than 80% RH.
∙ Remove the lid and use the handle to take out the water tank. Fill the tank with
cold tap water or distilled water.
∙ Place the water tank on the base and put the lid on.
∙ Connect the device. If there is no water in the tank, the device lights up red.
∙ The display lights up briefly and a signal sounds. The device is in stand-by mode.
∙ Touch the ON / OFF button 13). The device lights up blue and the display shows the
current humidity. After 15 seconds it starts to nebulisation level 2.
∙ Nebulisation level 15):
o The nebulisation level can be selected by touching the button:
o Level 1 = low
o Level 2 = medium
o Level 3 = high
o The selected value is shown in the display.
o If the current humidity is displayed, touch button 15) to check the nebuli-
sation level.
o Press again to change the level.
∙ Timer 14):
o Touch the button. The display shows 01 hours.
o The timer can be selected from 01 to 12 hours by repeatedly touching the
button. If "- -" appears in the display, the timer has been deleted.
o After selecting the time, the LED stops flashing after 5 seconds, the timer
is set.
o The display changes back to the current humidity after 1 minute. Has the
timer e.g. If programmed to 12 hours, the remaining time of 11 hours is
shown in the display after 1 hour of running.
∙ Humidity control 16):
o Touch the button. The display shows the current humidity.
o By repeatedly touching the key, the humidity can be selected in steps of
5% RH between 30 and 90% RH.
o If "CO" is shown in the display, this means continuous operation.
o After selecting the humidity, the LED stops flashing after 5 seconds, the
humidity is set.
o The display switches back to the current and selected humidity after 1 mi-
nute.
o If the selected humidity is 16% RH and more higher than the current one,
the device works at level 3.
o If the selected humidity is 10 - 15% RH higher than the current one, the
device works at level 2.
o If the selected humidity is 1 - 9% RH higher than the current one, the de-
vice works at level 1.
o If the selected humidity is lower than the current one, the device is in
stand-by mode.
o The nebulisation level can still be changed.
17