Installation And Connection; Tools Required; Installing And Connecting The Control Box - Dometic PERFECTVIEW AMP 100 Instructions De Montage Et De Service

AMP100
6

Installation and connection

6.1

Tools required

For installation and assembly, you will need the following tools:
• Measuring ruler (fig. 1 4, page 3)
• Centre punch (fig. 1 5, page 3)
• Hammer (fig. 1 6, page 3)
• Drill bit set (fig. 1 7, page 3)
• Electric drill (fig. 1 8, page 3)
• Screwdriver (fig. 1 9, page 3)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (fig. 1 1, page 3) or voltmeter (fig. 1 2, page 3)
• Insulating tape
• Heat shrinking sleeve
• Hot air blower (fig. 1 10, page 3)
• Crimping tool (fig. 1 11, page 3)
• Soldering iron (optional) (fig. 1 12, page 3)
• Solder (optional) (fig. 1 13, page 3)
• Cable bushing sleeves (optional)
6.2

Installing and connecting the control box

The control box is supplied ready for installation.
➤ Install the control box in a location protected from water near the monitor, preferably under
the dashboard.
Make sure you consider the length of the cable.
➤ Attach the control box using the supplied screws.
➤ Insert the plug and the cable set in the connection provided (12 – 24 V) on the control box.
➤ Connect the black cable (fig. 5 9, page 5) to earth.
➤ Connect the red cable (fig. 5 8, page 5) to an active positive cable (such as terminal 15).
A
NOTICE!
Ensure that you connect the control cables correctly to + PLUS and not to earth.
Connecting the control cables to earth can damage the device.
EN
Installation and connection
11