Attaching Or Removing Battery Pack - Panasonic EY7460 Instructions D'utilisation

III. ASSEMBLY
Attaching or Removing Bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
This tool is equipped with a keyless
drill chuck.
1. Attachment
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
2. Removal
Turn the
counterclockwise (looking from the
front), then remove the bit.
NOTE:
If excessive play occurs in the chuck,
secure the drill in place and
open the chuck jaws by turning the
lock collar and
(left-handed
screwdriver
counterclockwise (viewed from the
front).
Lock collar
lock collar
tighten the screw
screw) with
by turning
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
Line up the alignment marks and
attach the battery pack.
• Slide the battery pack until it locks
into position.
Alignment marks
2. To remove the battery pack:
Push on the button from the front to
release the battery pack.
Button
Support handle
Place the support handle at your
favorite position and tighten the
handle securely.
a
it
Tighten
Loosen
Remove the handle when placing the
tool in the storage case.
- 7 -