Safety And Installation Considerations - Solid State Logic Duende Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Safety and Installation Considerations

This section contains definitions, warnings, and practical information to ensure a safe working environment.
Please take time to read this section before installing or using this unit. Please do not dispose of these instructions.
General Safety
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Do not expose this apparatus to rain or moisture.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves
or other apparatus (including amplifiers) that produce heat.
• There are no user-adjustments, or user-servicable items, inside this
apparatus. Do not remove the covers of this apparatus; doing so will
invalidate your warranty.
• Adjustments or alterations to this apparatus may affect the performance
such that safety and/or international compliance standards may no longer
be met.
Caution
• To reduce the risk of electric shock, do not perform any servicing other than
that contained in these Installation Instructions unless you are qualified to
do so. Refer all servicing to qualified service personnel.
• A high quality IEEE1394/Firewire 400 cable is supplied. Use of alternative, inferior cables may result in reduced performance, including increased
susceptibility to external interference.
• Although IEEE1394/Firewire permits 'hot-plugging' there are persistant reports of permanent damage caused to either host or peripheral equipment by this
practice. Therefore, Solid State Logic strongly recommends that IEEE1394/Firewire connections are made only when both the host and Duende units are
unpowered.
Power Safety
• This apparatus is supplied with a universal power supply, approved and
certified for operation with this apparatus – adaptors are supplied to enable
use world-wide, as required. There are no user-replaceable fuses.
• Where the universal power supply is required, use only the Solid State Logic
provided power supply. Use of any other power supply is not covered by
your warranty and may cause fire or explosion.
• Any external power supply may become hot during normal operation of the
unit. Use care when handling the power supply.
• Do not attempt to modify the power supply unit in any way – other than to
fit the appropriate power adaptor, as required (see overleaf).
• If an extension power cable or adaptor is used, ensure that the total power
rating of the power cable and/or adaptor is not exceeded.
• The power socket used for this apparatus should be located nearby and be
easily accessible.
• Unplug this apparatus during an electrical storm or when unused for long
periods of time.
Installation Notes
• When installing this apparatus, place the apparatus on a secure level surface.
• Ensure that no strain is placed on the cables connecting to this apparatus.
Ensure also that such cables are not placed where they can be stepped on,
pulled or tripped over.
• Do not operate this apparatus whilst it is covered or boxed in any way.
EN
DE
FR
ES
IT
1

Publicité

Table des Matières
loading

Table des Matières