Safety And Installation Considerations - Solid State Logic MYNX Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Safety and Installation Considerations

This section contains definitions, warnings, and practical information to ensure a safe working environment.
Please take time to read this section before installing or using this unit. Please do not dispose of these instructions.
General Safety
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Do not expose this apparatus to rain or moisture.
• Clean only with dry cloth.
• Take care of rough or sharp edges when installing or removing modules.
• Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves
or other apparatus (including amplifiers) that produce heat.
• Adjustments or alterations to this apparatus may affect the performance
such that safety and/or international compliance standards may no longer
be met.
Caution
• To reduce the risk of electric shock, do not perform any servicing other than that contained in these Installation Instructions unless you are qualified to do so.
Refer all servicing to qualified service personnel.
Installation Notes
• When installing this apparatus, place the apparatus on a secure level surface.
• Ensure that no strain is placed on the cables connecting to this apparatus. Ensure also that such cables are not placed where they can be stepped on, pulled or
tripped over.
• Do not operate this apparatus whilst it is covered or boxed in any way.
• Do not install or remove modules with power applied. Damage may be caused to either the module or this apparatus.
• To prevent damage from static electricity when installing or removing modules, either to the module(s) or to this apparatus, always take proper anti-static
precautions. Always use an anti-static wristband. If in doubt, please refer to qualified service personnel.
• To ensure peak operating performance, please ensure all front and rear panel fixing screws are securely tightened.
Power Safety
• This apparatus is supplied with a universal power supply, approved and
certified for operation in this apparatus. There are no user-replaceable fuses.
• Use only the Solid State Logic provided power supply and power cord. Use
of any other power supply or power cord is not covered by your warranty
and may cause fire or explosion.
• Any external power supply may become hot during normal operation of the
unit. Use care when handling the power supply.
• Do not attempt to modify the power supply unit in any way.
• If an extension power cable or adaptor is used, ensure that the total power
rating of the power cable and/or adaptor is not exceeded.
• An external disconnect device is required for this apparatus; a detachable
power cord, as provided with this apparatus, is a suitable disconnect device.
• The power socket used for this apparatus should be located nearby and be
easily accessible.
• Unplug this apparatus during an electrical storm or when unused for long
periods of time.
EN
DE
FR
ES
IT
1

Publicité

Table des Matières
loading

Table des Matières