Specific Safety Rules - CEVIK EVOMAX 200 Manuel D'instructions

EN
USE AND MAINTENANCE OF THE MACHINE.
• Use jaws or some other practical way to secure and sustain the work piece to a stable
platform. Holding the work piece with your hands or against your body is unstable and
can lead to loss of control.
• Do not force the machine. Use the machine following the specifications. That way, the
machine will perform better and more safely the work for which it was designed.
• Do not use the machine if the switch (9) does not turn on or off. Any machine that cannot
be controlled with the on/off switch is dangerous and must be repaired.
• Disconnect the plug from the power source before making any adjustments, changing
accessories or storing the machine. These preventive measures reduce the risk of the
machine turning on accidentally.
• Store electrical machines out of the reach of children and anyone else who is not trained
for its operation. The tools are dangerous in the hands of users who are not properly
trained.
• Always keep the machine in good condition. Machines properly maintained are less likely
to suffer breakdowns or cause accidents.
• Check for misalignment or jamming of moving parts, broken parts, or any other anomaly
before use. Many accidents are caused by machines with poor maintenance.
• Use only accessories recommended by the manufacturer of your model. Accessories that
work for a specific machine can be dangerous when used with another.
• Do not alter or misuse the machine. This machine was built with accuracy. Any alteration
or modification not specified is a misuse and can lead to dangerous situations.
• The use of an appropriate safety device, such as a thermal and differential switch, is
recommended when using electrical equipment.
REPAIR.
• The repair of the machine must be carried out only by qualified staff. Repair or maintenance
performed by an unqualified person can lead to risk of injury.
• Only the spare parts or accessories recommended by the manufacturer should be used for
the maintenance of the machine. Follow the instructions in the maintenance section of this
manual. The use of unauthorized parts or failure to follow maintenance instructions may
result in the risk of electric shock or injury.
SPECIFIC SAFETY RULES FOR WELDING MACHINES.
THERMAL PROTECTION.
The equipment is protected against thermal overloads via an automatic recharge thermostat.
When the set maximum temperature is reached, the protection will cut off the power circuit
current and the warning light will light up (3). DO NOT TURN OFF OR DISCONNECT THE
EQUIPMENT WHILE THE THERMAL PROTECTION IS ACTIVE, AS DOING SO MAY CAUSE SERIOUS
DAMAGE TO THE MACHINE. After a few minutes, the warning light will go out and the power
will come back. The equipment will then be ready to resume operation.
35
•