Christopeit Sport SP 10 Mode D'emploi page 25

Step 9:
Installation of cable 2 for butterfl y (73) with double pulley holder 90°
(56).
1. Connect the both ends of cable 2 (73) with the appropriate holder at
butterfl y arm left and right (10L+10R) as fi gure shows (leaded behind the
centre support (3)) by using screws M10x25 (59) and nuts M10 (18).
2. Insert one pulley (23) with cable 2 (73) into the double pulley holder 90°
(56). Put a washer (20), plastic ring (75) and cable slide (22) onto the
screw M10x60 (21) and put the screw (21) through the double pulley
holder 90° (56) with pulley (23). Place a plastic ring (75), cable slide (22)
washer (20) and nut (18) onto the screw end and tighten it.
3. Now install the second pulley (23) with necessary parts without a cable
at double pulley holder 90° (56). The pulleys (23) should move easy. Then
put a screw cap (19) onto all screw heads (21) and nuts (18).
Step 10:
Installation of cable 1 for leg curler (72) with double pulley holder
(55).
1. Insert two pulleys (23) into the double pulley holder (55). Put a washer
(20), a plastic ring (75) and a cable slide (22) onto the screws M10x60
(21) and put the screw (21) through the double pulley holder (55) with
pulleys (23). Place a plastic ring (75), cable slide (22), washer (20) and
nut (18) onto the screw ends and tighten them. The pulleys (23) should
move easy. Then put a screw cap (19) onto all screw heads (21) and nuts
(18).
2. Pull cable 1 (72) with eye end through the leg curler (14) and around the
pulleys as fi gure shows and connect the end of cable 1 (72) at appropriate
holder on main base (1) by using chain (71) and carbine hooks (81).
3. Connect the curl bar (86) at cable 1 (72) by using the chain (71) and
carbine hooks (81). (When you use leg curler for exercising you should
take away the curl bar (86) with chain (71).
25