Operating Modes; Exhaust Air Mode; Air Recirculation; Getting To Know Your Appliance - Siemens LB53NAA30 Mode D'emploi

Operating modes

en
ÇOperating modes
E xhaust air mode
O p e r a t i n g m o d e s
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air must not be discharged into a flue that is
Note:
used for exhausting fumes from appliances burning gas
or other fuels (not applicable to appliances that only
discharge the air back into the room).
Before conveying the exhaust air into a non-
■
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
If the exhaust air is conveyed through the outer wall,
■
a telescopic wall box should be used.

Air recirculation

The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter, and is conveyed back into
the kitchen.
To bind odours in air recirculation mode, you
Note:
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or from
the Online Shop.
14
*Getting to know your
appliance
H ere, you can get to know your appliance and receive
G e t t i n g t o k n o w y o u r a p p l i a n c e
information about the accessories.

( Control panel

0 Lighting
8 Metal grease filter
Control panel
Symbol Explanation
Switches on fan setting 1 / Switches the fan off
#
2 Switches on fan setting 2
3 Switches on fan setting 3
Switches the lighting on/off
=