Shelf Runner Assembly And Disassembly; Folding The Heating Element Down/Away; Regeneration Of The Ökotherm® Catalyst; Assistance In The Event Of Malfunction - Kuppersbusch EEB6860.1 Manuel D'utilisation

Attaching the oven door.
– Hold the oven door with both hands and insert the hinges in the corres-
ponding slots. The hinge should fi t snugly.
– Slowly open the door fully.
– Again lower the supports on the door
hinges.
– Close the oven door.

Shelf runner assembly and disassembly

Removing the shelf runners
– Remove the shelf runners by loosening them from the chrome nuts that
are located on the sides of the oven.
– Remove the shelf runner.
Assembling the shelf runners
– Position the shelf runners and attach the nuts.

Folding the heating element down/away

Fold down the heating element (Top heat/Grill)
– Open the lock and fold down the
heating element.
Fold away the heating element.
– Fold away the heating element and
close it again with the lock.
Regeneration of the ökotherm®
catalyst
The ökotherm® catalyst dissolves the grease particles and smells
produced when roasting with the Hot Air cooking setting. This process is
suffi cient with the normal use of the Hot Air setting. In special cases
(well-cooked roasts in large quantities) it is possible that small grease
particles will be deposited on the catalyst. When you use the oven again
e.g. when cooking a pizza, they will be gradually dissolved.
If you believe that the catalyst is not cleaning as well as it should
(it smells a lot) you can regenerate it by eliminating the remains of
accumulated grease.
Regeneration of the ökotherm® catalyst
– Select the Hot Air service function.
– Set the thermostat to 200° C and
– heat the empty oven for 60 mins.
Assistance in the event
of malfunction
Repairs must only be carried out by an authorised professional.
You may be able to solve some malfunctions yourself. First check if there
has been a problem with the way it is being used. Repairs during the
guarantee period are not exempt from costs in the case of an error in
the way it is being used or if you have not noticed one of the following
situations.

What to do if...

... the sensors or lights do not work.
Check: Is the socket plugged in? Is the fuse in good condition? Has there
been a power failure? Is the child safety lock on?
... one or several sensors do not react to contact but it is possible to
connect the lighting.
Possible cause: The sensors continuously adapt their sensitivity to
ambient conditions. In unfavourable circumstances e.g. if someone leans
on them for a long period of time, it may take several minutes until the
sensors react again.
Wait approximately 15 seconds or disconnect and reconnect the fuse.
Repeat the procedure again if necessary.
The keys will then be reset and will react again on contact.
... one or several sensors do not react after the fuse has been discon-
nected and then reconnected.
Possible cause: Faulty sensor key or element.
After disconnecting and reconnecting the fuse twice, disconnect the fuse
again and inform the after-sales service.
47