Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Configuration
(DMX)
Starting Address
DMX
Personalities
Freedom™ PAR & Strip Mini User Manual (Rev. 7 ML)
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
3.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Freedom™ series uses up to four (4) DMX channels in 4-channel DMX mode, which
defines the highest configurable address to 509.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2.
Use <UP> or <DOWN> to select SYS.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select SdAd from the menu.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select the starting address.
7.
Press <ENTER>.
The Freedom™ series has two DMX personalities. One is a basic 3-channel personality,
and the other is a more advanced 4-channel personality.
To select either the Freedom™ series' 3- or 4-channel personalities, use the following
steps:
1.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2.
Use <UP> or <DOWN> to select SYS.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select d-CH from the menu.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select either the basic 3-channel mode (3CH) or the
advanced 4-channel mode (4CH).
7.
Press <ENTER>.
Page 15 of 76
Publicité
Table des Matières
