Thermador MASTERPIECE SGS Série Guide D'installation page 8

Note: All measurements given must be precisely
followed. If nonstandard cabinets are used, make sure
they are installed with minimum dimensions shown in
image above.
Plan the installation of the unit so that the power cord,
gas shut-off valve and gas pressure regulator are
accessible from the front of the cabinet.
Countertop Requirements
Notes
All measurements given must be precisely followed. If
▯
nonstandard cabinets are used, make sure they are
installed with minimum dimensions shown in image
below.
When installed in combination with a hood, refer to
▯
hood manufacturer's requirements for installation
30" Models
max. 3" (76)
* Side wall clearance dimensions can be reduced to 6"
(152 mm) if opposing side wall is ≥ 24" (610 mm).
8
36" Models
max. 3" (76)
* Side wall clearance dimensions can be reduced to 6"
(152 mm) if opposing side wall is ≥ 24" (610 mm).
gas
connection
Mounting Requirements
Use the hold down brackets supplied. See "Install the
Cooktop" section for further details.
Ventilation Requirements
We strongly recommend the installation of ventilation with
the appliance. The appliance must be installed according
to the furnished instructions.
CAUTION
9
( )=mm
The appliance should not be installed with a
ventilation system that blows air downward toward
the burners. This type of ventilation system may
cause ignition and combustion problems with the
gas cooking appliance resulting in personal injury or
unintended operation.
gas
connection
( )=mm