3-Pin To 5-Pin Conversion Chart; Setting Up A Dmx Serial Data Link - Chauvet DJ Obey 3 Mode D'emploi

3-Pin to 5-Pin Conversion Chart

If you use a controller with a 5-pin DMX output connector, you will need to use a 5-pin to 3-pin
adapter. The chart below details a proper cable conversion:
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Not used
Not used

Setting up a DMX Serial Data Link

1. Connect the (male) 3-pin connector side of
the DMX cable to the output (female) 3-pin
connector of the controller.
2. Connect the end of the cable coming from
the controller which will have a (female)
3-pin connector to the input connector of
the next fixture consisting of a (male) 3-pin
connector.
3. Then, proceed to connect from the output
as stated above to the input of the following
fixture and so on.
5. Appendix
3-P 5-P C C
IN TO IN ONVERSION
3-Pin Female (Output)
Pin 1
Pin 2
Pin 3
Continue the link
15
HART
5-Pin Male (Input)
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Universal DMX Controller
This drawing
provides a general
illustration of the
DMX input/output
panel of a lighting
fixture.