Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3510 2610008262 ENG:SM 2610008262 12-09 3/26/10 9:03 AM Page 17
Read instruction manual first! Remove plug from the power source before
WARNING
!
making adjustments or assembling the blade.
TROUBLE: SAW WILL NOT START
PROBLEM
1. Power cord is not plugged in.
2. Power source fuse or circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
5. Trigger does not turn tool on.
REMEDY
1. Plug saw in.
2. Replace fuse or reset tripped circuit breaker.
3. Inspect cord for damage. If damaged, have cord replaced by an Authorized
4. Have switch replaced by an Authorized Skil Service Center or Service
5. Have switch replaced by an Authorized Skil Service Center or Service
TROUBLE: BLADE DOES NOT COME UP TO SPEED
PROBLEM
1. Extension cord too light or too long.
2. Low house voltage.
REMEDY
1. Replace with adequate cord.
2. Contact your electric company.
TROUBLE: EXCESSIVE VIBRATION
PROBLEM
1. Blade out of balance.
2. Workpiece not clamped or supported properly.
REMEDY
1. Discard blade and use different blade.
2. Clamp or support workpiece as shown on pages 11 and 14.
TROUBLE: CANNOT MAKE SQUARE CUT
PROBLEM
1. Foot not adjusted properly.
REMEDY
1. See "Operating Instructions" section, "Bevel Adjustment"
TROUBLE: CUT BINDS, BURNS, STALLS MOTOR WHEN CUTTING
PROBLEM
1. Dull blade.
2. Warped tile.
3. Blade binds.
4. Improper workpiece support.
REMEDY
1. Discard blade and use a different blade.
2. Make sure concave or hollow side is facing "DOWN"; feed slowly.
3. Assemble blade and tighten per "Assembly" instructions (page 10).
4. Clamp or support workpiece as shown on pages 11 and 14.
TROUBLE: BLADE SLIPPING
PROBLEM
1. Tool does not cut workpiece.
REMEDY
1. Assemble blade and tighten per "Assembly" instructions (page 10).
Troubleshooting
Skil Service Center or Service Station.
Station.
Station.
(page 11), and "Cross Cuts" (page 13).
-17-
Publicité
Table des Matières
