Storch LP Série Mode D'emploi page 145

LCD display
1. Lower the pressure regulator unit as described above.
2. Release the two nuts in the LCD display assembly and remove the assembly.
3. Re-assemble in reverse order, taking care that the two spacers and the two washers are correctly seated. Tighten
the two nuts hand-tight and lock them with blue Loctite. Do not tighten the nuts too tight to avoid damaging the
display.
INSTRUCTIONS:
The device cannot be operated if cables are missing or kinked. On re-assembly, make sure that all cables are connected
and that they are not kinked.
145