Fagor SBE9-10 Instructions Pour L'installation, L'utilisation Et L'entretien page 19

When the vat reaches the selected temperature the pilot light turns off and the resistors stop operating.
Furthermore, when the temperature drops below the selected value, the amber pilot light turns on and the
resistors start to operate.
Safety thermostat
The safety thermostat works when the maximum admissible temperature is exceeded making it impossible
to use the appliance. To start it up again, reset the safety thermostat, situated on the back of the control
panel, pressing the red button. (Fig.4)
If the safety thermostat were to cut off again, call the Technical Assistance Service.
Emptying the vat.
To facilitate emptying the vat and cleaning, the appliance has a lifting device which can be:
a) A lever located on the front part. It is lifted turning this lever clockwise.
b) A motor is activated with the up-down switch.
Daily cleaning
Clean all the stainless steel surfaces and the inside of the vat daily with lukewarm water and detergent.
Rinse with plenty of cold water and dry it, paying special attention to the bottom of the vat.
Do not scratch the stainless steel surfaces with spatulas or iron wire brushes.
It is not necessary to use water hoses to clean the appliance as they may damage its operating
components.
If they are not going to be used for a long while, cover the surfaces with a thin layer of Vaseline, above all
inside the tub.
Operating components
- Adjustment thermostat
- Safety thermostat
- Resistor
The replacement of a functional component must be carried out by an AUTHORISED TECHNICIAN.
As a rule, whenever an operating component is being replaced, the electric current to the appliance must
be cut off with the general power switch.
Operation
3.- Maintenance
18