Important - Master DH 745 Manuel D'utilisation Et De Maintenance

Masquer les pouces Voir aussi pour DH 745:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
en
1... WHERE TO POSITION
it
2... BEFORE USE
de
3... PARTS
4... OPERATION
es
5... DRAINAGE
6... MAINTENANCE
fr
7... TROUBLE SHOOTING
nl
pt
PLEASE TAKE TIME TO READ THIS MANUAL CARE-
FULLY BEFORE USE AND SAVE IT FOR FUTURE REF-
ERENCE.
da
►►
1. WHERE TO POSITION (FIG. 1.)
fi
Excess moisture will travel throughout your home, in the same
way that cooking smells waft to every room in the house. For this
reason, the dehumidifier should be positioned, so that it can draw
no
this moist air towards it from all over the home.
Alternatively, if you have a serious problem in one area you can
sv
begin by positioning the dehumidifier close to this area and later
moving it to a more central point. When positioning the dehumidi-
fier, ensure that it is placed on a level surface and that there is a
pl
minimum of 10 cm (4") of space on either side of the unit to al-
low for efficient airflow. This dehumidifier is fitted with castors for
ru
extra mobility, if you move the unit, it should first be switched off
and the water tank emptied. We do not recommend the use of an
extension lead, so please try to ensure that the unit is sufficiently
cs
close to a fixed mains socket. If it is necessary to use am exten-
sion lead, please ensure the diameter of the wires of the cable is
hu
at least 1 mm2. When the dehumidifier is in operation, outside
doors and windows should be closed when necessary for most
efficient use.
sl
►►
2. BEFORE USE
hr
CAUTION!
► Always keep the unit in vertical position.
► Leave the unit to stand for one hour before connecting to the
lt
mains supply after transport or when it has been tilted (e.g. during
cleaning).
lv
► Keep all foreign objects away from the air intake or output
openings.
► The mains supply must conform to the specification shown on
et
the rating plate at the back of the unit.
► If the supply cord is damaged, it must be replaced by an ap-
ro
proved service representative or a similar qualified person in or-
der to avoid a hazard.
► Never use the plug to start and stop the unit. Always use
sk
switch on the control panel.
► Before moving the unit, first switch off, then unplug and empty
the water tank.
bg
► Don't use bug sprays or other flammable cleaners on the unit.
► Never pour or spray water over the unit.
uk
► THIS APPLIANCE IS NOT INTENDED FOR USE BY PER-
SONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERI-
zh
ENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN
SUPERVISION OR INSTRUCTION CONCERNING USE OF
SE
THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR
SAFETY. CHILDREN SHOULD BE SUPERVISED TO ENSURE
THAT THEY DO NOT PLAY WITH APPLIANCE.
SE
SE
SI
CONTENTS

IMPORTANT!

DO NOT USE THIS UNIT AT AMBIENT TEMPERA-
TURES BELOW 5ºC, TO PREVENT THE POSSIBILITY
OF A HEAVILY ICE UP EVAPORATING COIL.
►►
3. PARTS (FIG. 2.)
1. Front Plate
2. Control Panel
3. Air Outlet
4. Handle for the unit
5. Rear plate
6. Power cable
7. Filter inlet
8. Drain hole for continuous drainage
9. Water tank
10. Castors
►►
4. OPERATION (FIG. 3.)
1. Humidity selection button
2. Speed (ventilation) button
3. Display window
4. Temperature display button
5. ON/OFF button
6. Humidity indicator
7. High speed indicator
8. Low speed indicator
9. Timer
10. Water full indicator
11. ON/OFF indicator
12. TiO2 indicator
13. TiO2 button (optional)
► Plug the unit into a correct mains socket. (Please refer to the
rating label at the rear of the unit for correct voltage/frequency.)
► Press button ON/OFF to turn on the unit. The compressor will
start to work in continuous mode. (Ionizer (optional) will start run-
ning automatically.)
► Press button HUMI to set the room humidity you need: con-
tinuous de-humidifying , 40%, 50%, 60% or 70%. (When the room
humidity is under 35%, the display will show 'LO' and if the room
humidity is over 95%, it will show 'HI'.)
► Press the speed button to choose the ventilation speed, high
or low.
► Press the temperature button to display the room tempera-
ture. It will revert to display the room humidity after 12 seconds.
► Press the timer button to set up the time for turn on/turn off
(1~24hr). The unit will be continuous de-humidifying without timer
setting.
► Press TiO2 button to start the TiO2. (Optional)
► To turn off the unit, press button ON/OFF again.

Publicité

Table des Matières
loading

Table des Matières