EGO POWER+ SNT2400E Manuel De L'opérateur page 8

EN
NOTICE: The speed is fixed when operating the snow
blower in reverse with self-propel; the speed-control
lever cannot change the speed in reverse.
NOTICE: The snow blower cannot be switched to
move backward while the self-propel function is
moving it forward.
AUGER SWITCH TRIGGER AND SELF-PROPEL
TRIGGER LINKAGE
When the self-propel trigger (A-18) and the auger-
switch trigger (A-13) are pressed at the same time
then release the auger-switch trigger (right hand), the
auger-switch trigger will remain engaged. This feature
allows you to adjust the auger speed, self-propelling
speed, and discharging direction of the snow while the
auger rotates.
To stop the auger, release the self-propel trigger, both
the auger and the self-propel function will stop.
CHUTE AND DEFLECTOR ADJUSTMENT
The chute can be adjusted to change both the
direction and the distance of the discharged snow to
assist you in moving snow away from one area and
placing it in another.
The direction of snow removal can be adjusted up to
left 100° and right 100°.
Pull the chute-rotation handle (A-22) to the left/right
to rotate the chute to the left/right.
The throwing distance of the snow blower is adjusted
by moving the chute deflector up or down.
To increase or decrease the distance that the snow
is thrown, pull the chute deflector handle (A-23)
backward or forward to raise or lower the chute
deflector (A-10). Once arriving at the desired chute
deflector position, engage the chute deflector handle
into the locking slot(F-1) (Fig. F).
LED SIDELIGHTS (A-12) AND HEADLIGHTS (A-6)
OPERATION
Press the LED light button once to turn on both the
sidelights and headlights.
Press the LED light button twice to turn off the
sidelights.
Press the LED light button three times to turn off all
the lights.
NOTICE: All the LED lights will turn off automatically if the
snow blower is not being operated within 5 minutes.
8
56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400E
LED INDICATOR (A-21) ON THE SNOW BLOWER
The snow blower is equipped with a LED indicator to
indicate the charge level of the battery pack(s) and the
working status of the snow blower.
LED
Meaning
INDICATOR
Snow blower is
working proper-
Shinning
ly; each battery
Green
has at least 15%
of its charge.
The battery is
Flashing Red
nearly depleted.
Flashing
Green
Error
and Red
alternately
The snow blow-
Shinning
er stops due to
Orange
overheating.
Flashing The snow blow-
orange er is overloaded.
Battery overheat.
(See section
OFF & LED
"BATTERY HIGH-
on battery
TEMPERATURE
flashing
PROTECTION" in
this manual)
Action
n/a.
Stop the snow blow-
er and charge the
battery pack(s).
Contact EGO cus-
tomer service center
Remove the batteries
from the snow
blower, move them
to the shade and
cool them at least 15
minutes.
First remove the bat-
tery pack, then check
and clean if snow has
collected beneath
the deck. Slow down
your pace when snow
moving. If this does
not work, please
contact EGO customer
service center.
Remove the battery
from the snow
blower and wait
until the battery
pack cools down to
approximately 67°C,
then reinstall the
battery and restart
the snow blower.