EGO POWER+ SNT2400E Manuel De L'opérateur page 11

TROUBLESHOOTING
WARNING:
Always remove the battery pack(s) when servicing or transporting the snow blower. Always protect
your hands by wearing gloves when performing any maintenance on the snow blower auger or scraper.
PROBLEM
Snow blower is not starting.
The motor is on but the auger
does not turn on.
The LED light button is
insensitive to the first pressing.
e
The LED indicator on th
battery keeps on after the snow
blower auger stops working or
.
self-propel system turns off
WARRANTY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
CAUSE
◾
Battery charge is low.
◾
The auger-switch trigger is not
depressed at the moment of the LED
indicator flashing green.
◾
The auger is frozen by snow or ice.
◾
The battery is overteated. The LED
indicator on the battery flashes
orange or shines red (see the section
"BATTERY HIGH-TEMPERATURE
PROTECTION" in this manual)
◾
The shear pin is broken.
◾
The internal self-checking process
causes a slight delay in the first
.
keystroke response
◾
The electric circuit is in standby for
next restart. The LED will shut off
automatically if the snow blower is
not operated in 5 to 10 mintues.
56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400E
SOLUTION
◾
Charge the battery.
◾
Press the auger switch trigger when
the LED indicator blinks. If the LED
indicator stops blinking, the snow
blower will not be response to the
pressing of auger-switch trigger.
◾
Remove the battery pack(s) firstly, use
the supplied chute clean tool to clear
the snow or ice that obstructs on the
auger. Restart the snow blower.
◾
Remove the overheated battery
from the snow blower and wait
until the battery pack cools down to
approximately 67°C, then reinstall the
.
battery and restart the snow blower.
◾
Replace the shear pin following the
section "REPLACING THE SHEAR PIN"
in this manual.
◾
Press the LED light button and hold for
.
1 second
◾
Just leave it or remove the batteries
from the battery compartment.
EN
11