Philips Avent SCF334/03 Mode D'emploi page 12

ENGLISH
12
Cleaning and sterilising
The motor unit, the silicone tube and cap and the adapter do not require cleaning and sterilising,
as they do not come into contact with breast milk.
Clean and sterilise all other parts of the breast pump before first use. Also clean these parts after
each subsequent use and sterilise them before each subsequent use.
Danger: Never put the motor unit or the adapter in water or in a steriliser.
1 Disassemble the breast pump completely. Also remove the white valve.
Be careful when you remove the white valve and when you clean it. If it gets damaged, your
breast pump does not function properly. To remove the white valve, gently pull at the ribbed tab
on the side of the valve.
2 Clean all parts, except the motor unit, the silicone tube and cap and the adapter, in the
dishwasher (on the top rack only) or in hot water with some mild washing-up liquid and then
rinse them thoroughly.
To clean the valve, rub it gently between your fingers in warm water with some washing-up
liquid. Do not insert objects into the valve, as this may cause damage.
3 Sterilise the cleaned parts of the breast pump in a Philips AVENT steam steriliser or by
boiling them for 5 minutes.
Never put the motor unit or the adapter in water or a steriliser. If necessary, you can wipe the
motor unit with a soft, damp cloth.
Storage
Keep the breast pump out of direct sunlight as prolonged exposure may cause discolouration.
1 Store the breast pump and its accessories in a safe and dry place.
Compatibility
The Philips AVENT electric breast pump is compatible with Philips AVENT bottles in our range.
When you use Classic bottles that feature our two-piece anti-colic system, always insert the ring in
the top of the bottle before you attach it to the breast pump. When you use other Philips AVENT
bottles, use the same type of teat that was supplied with that bottle. For details on how to assemble
the teat and general cleaning instructions, refer to the user manual that came with your bottle.
These details can also be found on our website, www.philips.com/support.
Replacement
Batteries
Only replace the non-rechargeable batteries of the breast pump (SCF332 only) with four 1.5V AA
batteries (or 1.2V if rechargeable).
For instructions on how to replace the batteries see chapter 'Preparing for use'.
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips
dealer. You can also contact the Philips Consumer Care Centre in your country (see the worldwide
guarantee leaflet for contact details).