Guarantee And Support - Philips Avent SCF334/03 Mode D'emploi

Recycling
- This symbol on a product means that the product is covered by European Directive 2012/19/EU
(Fig. 13).
- This symbol means that the product contains batteries covered by European Directive
2006/66/EC which cannot be disposed of with normal household waste (Fig. 14).
- Inform yourself about the local separate collection system for electrical and electronic products
and batteries. Follow local rules and never dispose of the product and batteries with normal
household waste. Correct disposal of old products and batteries helps prevent negative
consequences for the environment and human health.
Removing the disposable batteries
To remove the disposable batteries, see chapter 'Preparing for use', section 'Assembling the breast pump'.

Guarantee and support

If you need information or support, please visit www.philips.com/support or read the separate
worldwide guarantee leaflet.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country or visit us online at www.philips.com/support.
Problem
I experience pain
when I use the breast
pump.
The breast pump is
scratched.
The breast pump does
not work and the on/
off button flashes.
I do not feel any
suction.
I need to replace the
silicone tube, but do
not know how to
remove it.
Solution
Stop using the breast pump and consult your breastfeeding advisor. If the pump
body does not come away easily from the breast, it may be necessary to break
the vacuum by placing a finger between the breast and the massage cushion.
In case of regular use, some light scratching is normal and does not cause
problems. However, if a part of the breast pump becomes badly scratched
or if it cracks, stop using the breast pump and contact the Philips
Consumer Care Centre or visit www.shop.philips.com/service to
obtain a replacement part. Be aware that combinations of cleaning agents,
sterilising solution, softened water and temperature fluctuations may, under
certain circumstances, cause the plastic to crack. Avoid contact with
abrasive or antibacterial detergents as these can damage the plastic.
First check if you have assembled the breast pump correctly and make sure
that there is no kink in the tube. If you are using SCF332 with batteries,
replace the batteries according to the instructions in chapter 'Preparing for
use', action 5. If you are using SCF334 or SCF332 on mains electricity, check
to make sure you are using the adapter that was supplied with the product.
If the problem persists, contact the Consumer Care Centre in your country.
Check if you have assembled the breast pump correctly by following the
steps in chapter 'Preparing for use'. Make sure the silicone tube is firmly
attached to the motor unit and to the cap and diaphragm.
To remove the tube, grab it close to the motor unit and pull while twisting
it. To reconnect the tube, ease the tube back onto the connector on the
motor unit with a slight twisting motion. Make sure it is securely attached.
ENGLISH
13